Parts and accessories guru Josh Myrick scavenges a good used crankshaft out
of an R1100S damaged crankcase.

Andy installs a beautiful piggy back Wilbers 642 shock in an R1200GS

Ted reads out fault codes on a K1200GT

Adam performs a 600 mile service on a new R1200RT

Adam sets the flash sequence on a new R1200 RTP police bike

We are proud to say the following police agencies trust the BeemerShop to provide the best service possible:

• Santa Cruz County CHP
• Monterey County CHP
• UCSC Campus Police
• Santa Cruz City Police
• Scotts Valley Police

Ted machines an Airhead gearbox output shaft for the circlip modification.

Ted playing with one of his favorite toys, a very accurate Kwik-Way VS valve grinding machine.

Grinding valve seats during an unleaded conversion.

Ohlins springs swapped in-house with the factory Ohlins shock spring compressor.

Fork tubes get polished when fork seals are replaced at the BeemerShop.

Adam reassembles an R1150GS transmission.

Here are a couple shots from Ted's past.

Using an eccentrimeter, Ted checks valve seat concentricity during an unleaded conversion.
  — Dealernews magazine November 1995

One of Ted's tech sessions, this one on spline lubrication.
  —Square Route Rally, Thurmount, Md