Spline Lube TS-60
Processing...

Spline Lube TS-60

Not Yet Rated | Write the First Review
Code: TS-60

Price: $28.95

Choose size here:
Qty

Description
Reviews

TS-60 Spline Lube was designed in collaboration with Beemershop and TS Moly specifically to lubricate motorcycle drive splines, such as clutch input shaft splines, final drive output splines, and driveshaft coupling splines. This is not just a generic moly grease, however it can also be useful in many other applications where a high film strength moly based lubricant is indicated. We commonly use it for Airhead throttle gears and clutch cable nipples for example. Fully lab tested and formulated with synthetic base oil and 60% molybdenum disulfide, TS-60 withstands extreme heat and protects sliding spline components under heavy load. Uniform and durable boundary lubrication is provided on parts even when operating in wet and harsh environments. TS-60 is highly adhesive and will not fling off or dry out even under extreme conditions.


Specifications from extensive lab testing:

Cone Penetration, unworked (ASTM D217)…….....…..……………..285
Thickener Type…………………………………….…....Calcium Sulfonate
Dropping Point, oF (oC)……………………………….……....>500 (>260)
Solids oxidation, oF (oC)………………………………..…...…...750 (399)
Kinematic Viscosity (ASTM D445)
cSt@40oC.........................................................................................460
cSt@100oC......................................................................................35.4
Density, lb/gal @ 60oF (15.5oC) (Gardner Method)…………..…...15.19
Specific Gravity @ 60oF (15.5oC) (Gardner Method)…………......1.824
Four Ball EP, Weld Point, kg (ASTM D2596).....................................250
Four Ball Wear, Scar Width, mm…………………………………........0.85
Water Spray-Off, % Loss (ASTM D4049)…………………………...….2.6
Water Washout, % Loss (ASTM D1264)……………………..…….....1.35
Oil Separation (ASTM D4425)………………………………….….......1.50
Leakage Tendencies of Automotive Grease, g (ASTM D4290)
20h @ 320oF (160oC)..…………………………………………………0.02 
Copper Strip Corrosion for Greases (ASTM D4048) modified
212oF (100oC) @ 3hrs………………………….………………………...1B

Available Sizes: 2oz, 4oz, 8oz jars

For splines and other mechanical components, clean off old lubricant with solvent and blow dry. Using fine bristle brush, work TS-60 into crevices of splines leaving only a thin coating of grease on the spline surface. Brush off excess grease. For clutch spline applications, only apply to the transmission spline, do not apply to the female spline of the clutch plate.

Customer Ratings & Reviews

Be the first to rate this item!

Write Review